Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Trusted Chimney Inspection for Gravesend Homeowners
If your fireplace has started smoking back into the room, or you can’t remember the last time anyone looked up the flue, a proper inspection is how you find out what’s actually going on before you light another fire. Our technicians have up to 15 years of experience reading the inside of a chimney, and because we also do the repair work, an inspection here means real diagnostic information, not a checklist someone hands you on the way out the door. We serve Gravesend homeowners with same-day scheduling in most cases, and every visit ends with photo evidence you can look at yourself.
Gravesend’s housing stock includes a lot of older brick chimneys, and many of them have gone years without a proper look. The homes here are tightly packed, lots are narrow, and a chimney that’s cracked or missing a cap doesn’t get noticed until water is already inside. That’s the value of a real inspection: catching problems while they’re still small. Call (855) 342-5978 for a free estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
Key Takeaways
- Inspections are done at Level 1, Level 2, or Level 3 depending on what’s actually happening with your chimney.
- Camera and flue inspection are included where they’re needed, not sold as extras.
- Every recommendation comes with photographic evidence, so you can verify it.
- We do the repair work ourselves when it’s needed, so there’s no handoff to a second contractor.
What Our Chimney Inspection Service Includes
Not every chimney needs the same level of inspection. The three levels are not packages to upsell, they’re diagnostic categories, and the right one depends on what’s happening with your chimney. Here’s how each one works, and when you actually need it.
Level 1 Inspection
A Level 1 is the standard checkup: we look at all the readily accessible parts of your chimney and venting system, including the firebox, damper, flue from below, and the exterior where it’s visible from the ground or roof. You need one at least annually if your fireplace is in regular use, or any time you change fuel type or replace an appliance. In Gravesend, this is the inspection most homeowners schedule, and we do it thoroughly: a Level 1 from us includes a look up the flue with a light, a damper check, and a visual review of the chimney exterior for signs of spalling or water intrusion.
Level 2 Inspection
A Level 2 is required whenever you’re buying or selling a home, after a chimney fire, after an earthquake or other event that could have shifted the structure, or after any change in the appliance or fuel type. It covers everything in a Level 1 plus a video camera scan of the entire flue interior, and we inspect accessible attics, crawl spaces, and chimney clearances to combustibles. What we do specifically: we run a camera the full length of the flue and record it, so you get a photo report showing exactly what the interior looks like, cracks, gaps in the liner joints, and all.
Level 3 Inspection
A Level 3 is a deeper diagnostic used when a Level 1 or 2 has found a serious problem that can’t be understood without gaining access to concealed areas, sometimes requiring removal of parts of the chimney or adjacent construction. It’s not routine and you won’t be talked into one unnecessarily. When it’s needed, we explain exactly what we expect to find and why the access is required before anything is opened. If a Level 2 photo report shows a problem we can diagnose without opening anything, we tell you that.
Camera Inspection
Camera inspection means we run a color camera down the flue and record what it sees, and it’s the single most useful tool we have. It shows the inside of the liner: cracks, spalling brick, gaps at joints, and the kind of glazed creosote that a visual look from the firebox can’t detect. We do camera inspection as part of every Level 2, and whenever a Level 1 finds anything we can’t explain from outside. The recording is yours, and we walk you through it.
Flue Inspection
A flue inspection focuses specifically on the channel that carries smoke and gases out of the house, checking that it’s sized correctly for the appliance, that it has no cracks or gaps, and that it’s clear of blockages like bird nests, leaves, or heavy creosote. A flue that’s too large for the appliance drafts poorly; one that’s cracked lets gases into the house. In Gravesend, where many homes have original chimneys from a time when sizing was done differently, this check matters. We inspect the flue as part of a full-service visit and can recommend what needs doing if it’s under or oversized.
Real Estate Inspection
Real estate inspection is a Level 2 done for a real estate transaction, and it gives the buyer, seller, and their agents a clear picture of the chimney’s condition before closing. It covers the full flue camera scan, the accessible exterior, and any clearances to combustible material. We do these with particular care for documentation: the written report includes photos and video, so there’s no disagreement later about what was or wasn’t found. If you’re buying an older home in this area, this is one of the checks worth doing before you sign.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Brands We Service for Chimney Inspection
We work with professional-grade product lines, and we service what we install. Copperfield chimney products show up in a lot of the homes we see, and we know where their liners tend to wear at the joints and what a failing seam looks like on camera. DuraFlex flexible liner systems have their own characteristics: the crown connections and the way the liner sits inside the flue matter to how it drafts, and we inspect them with that in mind. HeatShield ceramic resurfacing is one of the systems we know best, and if a previous HeatShield repair was done, part of the inspection is checking that the coating is still bonded and doing its job.
Gelco is another line we work with regularly, and our inspection reports on Gelco installations are based on hands-on familiarity with how the products are put together. Our inspection is backed by real repair experience, so when we tell you a joint is sound or a liner needs replacement, it’s coming from someone who installs these components. Whether you have Copperfield, DuraFlex, HeatShield, or any other make, we can help. The brand isn’t the deciding factor in whether we can assess your chimney; the level of inspection is.
Signs You Need Chimney Inspection Right Now
- Smoke or odor backing into the room. If smoke rolls out of the fireplace when you light a fire, or you smell smoke in the house with no fire going, something is wrong with draft or the flue. It could be a blockage, a sizing issue, or a crack. Don’t keep trying to burn through it.
- Visible soot or creosote buildup on the damper or firebox. When you can see heavy black buildup, especially the glazed, shiny kind, the flue is loading up and hasn’t been cleaned in a while. That’s the condition that precedes chimney fires, and an inspection tells you how far it’s gone.
- Water stains or white staining on the chimney exterior. Brown stains on the ceiling near the chimney or white, chalky stains on the brick outside point to water getting in, usually through a failed cap or crown. Water is the most common cause of chimney deterioration in this area, and it doesn’t fix itself.
- Loose or crumbling mortar. If the mortar between the bricks at the top of the chimney is soft enough to crumble with a touch, the chimney needs assessment. Crumbling brick over a walkway or roof is a real concern, and the cause (usually water freeze-thaw) gets worse every winter.
- You’re buying or selling a home. A Level 2 inspection before closing is the standard for a reason: it’s the only time you get to see inside the flue before you own the house. Skipping it means inheriting whatever the last owner couldn’t see either.
Our Chimney Inspection Process – Step by Step
- 1
We talk through the symptoms first. What’s happening with your fireplace, when it started, when you last used it, and whether there’s been any smoke, odor, or water issue. This shapes which level of inspection makes sense before we touch anything.
- 2
We sweep before we inspect when needed. You can’t properly evaluate a flue with a thick layer of creosote on the walls. When sweeping is needed, we do it as part of the visit, which is also why an inspection here is backed by real repair experience, not a checklist.
- 3
Visual inspection of the firebox, damper, and accessible flue. We check the firebox for cracks in the brick, the damper for operation, and the flue from the firebox upward with a strong light. We also take a look at the attic and any exposed chimney structure if accessible.
- 4
Camera scan of the full flue. A camera on a flexible rod runs the full length of the flue and records the whole run. We look for cracks, gaps at joints, spalled brick, and any obstruction. The recording is reviewed with you during the visit, and failures are pointed out on the screen, not just described later.
- 5
Written report and photo evidence. We give you a written report with photos and video stills, a plain-language summary of what we found, and a recommendation. If repairs are needed, you get an estimate based on what’s actually there. If nothing’s needed, you’ll hear that too, and we tell you when the next check is due.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Chimney Inspection Cost in Gravesend?
Inspection pricing in Gravesend depends on the level of inspection and whether sweeping is included. The written estimate sets the final price, and the estimate itself is free.
| Service | Typical Estimated Range |
|---|---|
| Level 1 inspection | $100 – $175 |
| Level 2 inspection (with camera scan) | $175 – $300 |
| Safety inspection combined with sweep | $175 – $350 |
| Level 3 inspection (diagnostic access) | Priced per job by written estimate |
Those ranges are typical for this area, and what moves them is the level of inspection, whether the flue has to be swept first, the length and configuration of your flue, and whether you’re doing a real estate inspection with documentation. You avoid overpaying by knowing which level you actually need. A Level 1 is the annual checkup; a Level 2 is for real estate, after a chimney fire, or after a change in appliance or fuel. Real estate inspections carry documentation requirements, which is why they sit at the higher end. What’s included in the free estimate: a walk-through of what we found or expect to find, the level of inspection we recommend and why, and a written estimate for any repair if one is needed.
Chimney Inspection Near Gravesend – Our Service Area
We serve homeowners across Gravesend and the surrounding area, including Bensonhurst, Sheepshead Bay, Brighton Beach, Coney Island, Midwood, Dyker Heights, Flatlands, Borough Park, Marine Park, Mill Basin, and Bergen Beach. If your home is outside these areas, call and we’ll confirm whether we can reach you. For nearby homeowners, a chimney inspection can usually be scheduled within the week, and we book into the next available opening.
Serving Gravesend, NY – Our Local Coverage Area
We serve Gravesend and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Chimney Inspection in Gravesend
A chimney inspection is an assessment of your chimney and venting system, done at one of three levels depending on what’s needed. A Level 1 is a visual check of accessible parts; a Level 2 adds a camera scan of the full flue; a Level 3 involves opening up concealed areas to diagnose a serious problem. In Gravesend, the annual checkup is normally a Level 1, and you need a Level 2 at a home sale or after a chimney fire. We look at the whole system, not just the firebox, and you get a photo report afterward.
Most inspections take between 45 minutes and two hours, depending on the level. A Level 1 with no sweeping is on the shorter end. A Level 2 with a full camera scan and a written, photo-backed report is longer, and if sweeping is needed first, add more. Real estate inspections take a bit longer because the documentation is more detailed. We’ll tell you roughly how long to expect when we book the visit.
A Level 1 in Gravesend typically runs $100 to $175, and a Level 2 with a camera scan tends to be $175 to $300. A safety inspection bundled with a sweep usually lands between $175 and $350. The written estimate sets the final price, and the estimate is free. Call (855) 342-5978 for an exact quote. We answer 24/7, and estimates are free.
Yes, we inspect and service those lines and others. Copperfield and DuraFlex liner systems are common in this area, and we know where they tend to wear at connections and joints. If you have a HeatShield ceramic resurfacing in place, we check that the coating is still bonded as part of the inspection. Whether your system is one of these or another make entirely, we can assess it and tell you what it needs.
In most cases, yes. Call and we’ll check what’s available. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday, and we’re closed Saturday. A call outside dispatch hours is booked into the next opening.
Yes. Our inspection is backed by a satisfaction guarantee, and anything we recommend comes with camera evidence you can see for yourself. If we tell you a liner needs repair or replacement, you’ll be shown exactly why, with photos and video. If the work can safely wait, we’ll say so. And if you have a repair done, it’s covered by the guarantee attached to that work.
Clear the area around the fireplace so we have room to work, and don’t light a fire for at least 24 hours before the visit so the chimney is cool. If you have the last inspection report or any repair paperwork, have it out; it helps us understand the history of the flue. Let us know if there’s a woodstove insert or a gas appliance in the chimney, since that changes what we inspect. That’s all we need from you.
Schedule Your Chimney Inspection Service in Gravesend Today
A chimney that’s been checked is a chimney you can use with confidence, and the inspection itself is a short visit with answers you can hold in your hand. Call Chimney Sweep Gravesend at (855) 342-5978 for a free, no-obligation estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday. If your fireplace has been sitting unused or you’re buying a home in the area, let’s take a look before the next burning season.
Written by the team at Chimney Sweep Gravesend.