Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Cap & Crown Across Midwood
If you’re in Midwood and there’s a rusted cap on top of the chimney, or a crown that’s cracked and washing away, that chimney is doing more than you might realize. Most of Midwood’s tall exterior brick stacks vent basement gas boilers and water heaters. The cap and crown are the only things standing between coastal rain and the clay-tile flue below. We work on chimney systems like these all over Midwood, from the brick two- and three-family houses near Avenue J to the detached homes off Ocean Avenue, and we know what fails first here. Call (855) 342-5978. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.

Why Midwood Homeowners Call Chimney Sweep Gravesend for Chimney Cap & Crown
Cap and crown work is a small, specific job, and it’s easy to do badly. A lot of sweep-only companies will clean your flue and never look at the top of the stack, which is exactly where Midwood’s moisture problems start. We do the full chimney: sweep, inspection, cap, crown, liner, fireplace. That means when we photograph a washed-out mortar crown at your roofline, the recommendation comes from someone who actually rebuilds them, not a checklist. We name the brands we install because the materials matter as much as the labor, and our technicians have up to 15 years of experience on brick chimneys in this climate. One specialist for the whole chimney, with no handoff to a second contractor.
Midwood is also full of chimneys that aren’t fireplaces at all, and that’s the part a generalist tends to miss. A cap job on a boiler-flue chimney is foundation work for the appliance below it. We treat it that way.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Cap & Crown Services in Midwood
We handle every part of the chimney top, from a single replacement cap to a full crown rebuild on a 1920s stack. Here’s what the work looks like in Midwood.
Cap Installation in Midwood
A correctly sized cap keeps rain, birds and debris out of the flue while letting exhaust escape. On a Midwood chimney serving a basement boiler, that cap is protecting an appliance vent, so the fit and the material matter more than on a fireplace. We measure the flue opening and set a cap that seals the top without choking the draft.
Cap Replacement in Midwood
Galvanised caps rust through on salt-laden coastal air, and gas-appliance exhaust speeds that up. When a cap has been eaten down to rust lace, water runs straight into the clay-tile flue below. We pull the old cap and set a replacement sized to the stack, usually in stainless so it holds up to the humidity that finished off the last one.
Crown Repair in Midwood
The crown is the sloped mortar or concrete cap that sheds water off the top of the chimney. Original crowns on Midwood’s mid-century and pre-war brick houses crack and pull away from the stack under freeze-thaw, and once water tracks down the exterior brick it spalls. We rebuild the crown to slope water away from the flue, not toward it.
Crown Coating in Midwood
When a crown is sound but has hairline cracks, a coating can seal it before it fails. This is the lighter option, and it’s worth knowing when it’s enough and when a rebuild is the real fix. We’ll tell you which one your chimney needs, based on what we see up there.
Custom caps and multi-flue caps come up often in Midwood, since a single stack might serve both a boiler and a water heater. We build those to fit the actual flue arrangement. For the full scope of what we do at the roofline, see our chimney cap & crown work.
Trusted Brands We Service in Midwood
We work with professional-grade lines including DuraFlex, HeatShield, Gelco and Copperfield. These are names used in the chimney trade, and they’re the reason our caps and crowns are built for the long exposure Midwood chimneys see. We don’t claim to stock parts locally; we specify the right component for your stack and get it in promptly. What’s in a cap or a crown matters as much as who installs it, and we use materials built for the job rather than big-box substitutes.

See the difference
Before
After
Before
After
Before
AfterCommon Chimney Cap & Crown Problems We See in Midwood Homes
These are the failures that show up again and again on Midwood’s brick chimneys, and each one tracks back to the same two enemies: coastal moisture and time.
- Galvanised caps rusting through. Decades of salt-laden air and gas-appliance exhaust eat a galvanised cap from the inside out. Once it’s rust lace, rain runs straight into the boiler flue below.
- Original mortar crowns cracking. Freeze-thaw pulls the crown away from the stack. Water then tracks down the exterior brick and spalls it, and the damage moves below the roofline.
- Flashing seals opening up. On 1920s – 1950s masonry chimneys, the seal where the chimney meets the roof opens over time. Moisture finds its way into the clay-tile liner joints.
- Small gas-flue caps on stacks with no hearth. A lot of Midwood chimneys vent the boiler, not a fireplace, and the cap on top is the first line of defense for that appliance. When it fails, the boiler starts drafting poorly.
Pricing for Chimney Cap & Crown in Midwood, NY
Prices here reflect the age and height of Midwood’s brick chimneys and the materials that hold up to the coastal air. A typical single cap replacement in Midwood runs $200 – $450, and a stainless multi-flue or custom cap runs $400 – $900. Crown coating for hairline cracks runs $250 – $500. A full crown rebuild on a pre-war stack runs $600 – $1,400, depending on height and access. What moves the number is how much water damage the crown already caused and whether the flashing needs re-sealing. The written estimate sets the final price, and nothing is recommended without camera evidence you can see for yourself. The estimate is free.
We Also Serve Cities Near Midwood
We work on the same brick chimneys across Midwood and the neighborhoods around it. If you’re in Flatlands, Kensington, Bensonhurst or Flatbush, the housing stock and the moisture problems are much the same, and the cap and crown work is the same job: keep the rain out of the flue before it cracks it.
Serving Midwood, NY – Our Local Coverage Area
We serve Midwood and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Cap & Crown in Midwood
Yes. A chimney with a small gas flue cap and no hearth is almost certainly venting a basement boiler or water heater, and that cap and crown protect the appliance below it. Rain and freeze-thaw moisture enter at the top and crack the clay-tile liner, so the inspection is really about the vent, not a fireplace. Call (855) 342-5978. Estimates are free.
For most Midwood chimneys, yes. Galvanised caps rust through on salt-laden coastal air and acidic gas-appliance exhaust, and they tend to fail well before a stainless cap would. Stainless costs more up front and holds up far longer in this climate. Call (855) 342-5978 to price both for your stack.
A cracked crown lets water into the top of the chimney, and from there it tracks down the exterior brick and the clay-tile flue. That shows up as spalling brick, cracked liner joints and a boiler that drafts poorly. The fix is usually a crown rebuild that slopes water away instead of toward the flue. Call (855) 342-5978 for an inspection.
Once a year is the right interval for a Midwood boiler-flue chimney. The heating season here is long, and the flue sees constant condensate and acidic exhaust, so cracked tile and joint gaps can open up between seasons. A yearly camera check catches them while they’re still a coating and not a rebuild. Call (855) 342-5978 to book.
Yes. When a single Midwood stack serves both a boiler and a water heater, a multi-flue or custom cap fits over each flue and seals the whole top without choking either one. We measure the flue arrangement and build to fit. Call (855) 342-5978. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
If you’re in Midwood and the top of your chimney has a rusted cap or a crown that’s cracking away, it’s a small job now and a bigger one after another winter. Call (855) 342-5978 for a free estimate. We’ll show you what we find and tell you plainly whether it can safely wait.
Written by the team at Chimney Sweep Gravesend.