Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Cap & Crown Across Bensonhurst
If your chimney crown has a crack you can see from the alley, or your cap is missing altogether, you’re probably wondering who to call and what it should cost. Chimney cap and crown work in Bensonhurst is mostly a masonry job on old exterior stacks, and it needs someone who reads brick, not just metal. We handle cap installation, crown repair, multi-flue caps, and custom caps for the brick two- and three-family houses that fill this neighborhood. Our technicians have up to 15 years of experience, and every recommendation comes with camera evidence you can look at yourself before you spend a dollar.

Call (855) 342-5978. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Why Bensonhurst Homeowners Call Chimney Sweep Gravesend for Chimney Cap & Crown
Bensonhurst chimneys are old, and they’ve been worked on before. Many of these brick houses have had hearths added, boilers swapped, and flues rerouted over the years, which means the stack you have today might not match any drawing. We do chimney and fireplace work and nothing else, so our inspections are informed by real repair experience rather than a checklist walked through by a generalist.
That matters most when someone else has already told you the crown is shot and the liner needs replacing. Plenty of that work is genuinely necessary. Some of it isn’t. We put a camera in the flue and show you what’s there, so you can decide with your own eyes.
We install materials the trade trusts: Famco and Copperfield caps, HeatShield for liner resurfacing, DuraFlex stainless liners. Those names don’t show up at every sweep-only shop, and they hold up to coastal Brooklyn weather.
For Bensonhurst specifically, we know the layout. Semis on tight lots, chimneys inches from the neighbor’s wall, side yards too narrow for staging. Getting to a crown here takes the right ladder work, not a clean open roofline.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Cap & Crown Services in Bensonhurst
Cap Installation
A proper cap keeps rain, birds, squirrels, and debris out of an open flue. On Bensonhurst’s older masonry stacks, we measure the actual flue opening rather than guessing from the outside, because decades of additions mean the interior rarely matches what a previous owner described. Famco and Copperfield single-flue caps fit most of these stacks well.
Cap Replacement
A rusted, loose, or undersized cap does more harm than no cap, because a poor fit funnels water into the flue and lets wind rattle the metal against the crown. We pull the old cap, check the crown and top course of brick underneath, and set a correctly sized replacement. If the flue configuration has changed since the last cap went on, we’ll say so before ordering anything.
Crown Repair
The crown is the concrete pad at the top of the stack, and it takes the worst of what Brooklyn throws at it. Freeze-thaw cycles open hairline cracks that widen over winters, and once water gets under the crown it works into the mortar joints and the clay tile liner. Crown repair in Bensonhurst means rebuilding the slope so water runs off instead of pooling. Because these exterior chimneys often sit just inches from a neighbor’s wall, the repair is usually done from a ladder in a narrow shared alley, and we plan the job around that clearance.
Crown Coating
When a crown is cracked but still structurally sound, a flexible coating can seal it and buy years before a rebuild. This only works on a crown that has real material left. If the concrete is crumbling to the touch, coating is a waste of money, and we’ll tell you that plainly. Crown coating alongside a fresh sweep is one of the cleanest ways to close the loop between maintenance and weatherproofing.

Trusted Brands We Service in Bensonhurst
We work with professional-grade product lines: Famco and Copperfield for caps, DuraFlex for stainless liners, and HeatShield for ceramic liner resurfacing. These are materials certified chimney institutes use, not big-box substitutes. We don’t carry stock in Bensonhurst; caps and custom pieces are ordered to the measurements we take on site, and turnaround on a standard cap is typically a few days once it’s ordered. That’s the trade-off for getting a cap sized to your actual flue instead of a shelf SKU forced onto a non-standard stack. HeatShield resurfacing, where the liner qualifies, is applied in a single visit.
Common Chimney Cap & Crown Problems We See in Bensonhurst Homes
- Cracked crowns from freeze-thaw and water infiltration. Coastal Brooklyn’s humid summers and freezing winters stress exterior brick stacks, and the crown is the first thing to go. It’s often missed because in the tight side yards between semis, the crown is barely visible from the ground.
- Missing or wrongly sized caps on clay-tile and unlined flues. Rain, animals, and debris get in, which speeds up creosote buildup and causes draft problems. A cap that doesn’t match the flue opening is almost as bad as none.
- Spalling mortar and flue liner damage. Water that gets past a bad crown works into the mortar joints and the clay tile liner. Left alone, that’s a liner replacement instead of a crown repair.
- Undocumented flue configurations from generations of hearth additions. Many of these homes were built by Italian-American families who added or rebuilt hearths over the decades. Standard caps and crown repairs often won’t fit, so multi-flue or custom-fabricated solutions are sometimes the only correct answer.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Cap & Crown in Bensonhurst, NY
These are typical estimated ranges for the Bensonhurst market. A standard single-flue cap installation generally runs $250 to $550 installed, depending on cap type and flue size. Crown repair, rebuilt with a proper slope, typically lands between $700 and $1,600, and multi-flue or custom-fabricated caps run $700 to $1,400. A flexible crown coating is usually $350 to $650. What moves the number: alley access and ladder work on the tight side yards, the condition of the top brick courses, and whether the flue config is standard or custom. Nothing is recommended without camera evidence you can see for yourself, and the written estimate we give you sets the final price.
We Also Serve Cities Near Bensonhurst
We work across this corner of Brooklyn, including Bensonhurst and the neighborhoods around it. If you’re in Gravesend, Dyker Heights, Midwood, or Borough Park, the housing stock and the weather are much the same, so the same careful approach applies. Our chimney cap & crown team handles caps, crowns, liners, and everything else chimney-related.
Serving Bensonhurst, NY – Our Local Coverage Area
We serve Bensonhurst and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Cap & Crown in Bensonhurst
Most visible cracks can be repaired, not replaced. If the concrete still has solid material and the crack hasn’t separated the crown into loose pieces, we resurface and re-slope it rather than tear it off. A crown crumbling to dust, or one that’s pulling away from the flue, calls for a rebuild. We decide based on photos from up top, not a guess from the street. Call (855) 342-5978 for an exact quote. Estimates are free.
It matters, and the difference usually comes down to what was done to each house over the years. Caps get added with a boiler replacement, a hearth rebuild, or a liner job, and a house that never had that work done often still has an open flue. An open flue takes in rain and debris year round, which speeds creosote buildup and can cause draft problems. If your neighbor has one and you don’t, it’s worth a look. Call (855) 342-5978 for an exact quote. Estimates are free.
You can’t tell from the ground with any confidence, so we measure the flue opening directly. A correctly sized cap overlaps the flue with a small margin and sits level on the crown; an oversized one catches wind and rattles, and an undersized one leaves gaps for water and animals. On Bensonhurst’s brick multi-family setups, the flue configuration inside often doesn’t match outside expectations, so measuring is the only reliable way. Call (855) 342-5978 for an exact quote. Estimates are free.
A Level 2 inspection goes into the flue with a camera and looks at the full liner, joints, and connections, which is what you need before crown or cap work is signed off. It catches the liner damage that a bad crown causes and lets us show you the video. On the older, non-standard stacks common in Bensonhurst, this step is what keeps a repair honest. Call (855) 342-5978 for an exact quote. Estimates are free.
Yes, and this is common in Bensonhurst’s multi-family boiler setups. A cracked crown lets water into the clay tile liner and the mortar joints, and damaged joints break the seal that makes the flue draw properly. Draft problems show up as a smoky smell, uneven heat, or a boiler that struggles. Repairing the crown often restores the draft without touching the liner, which is why we fix the top before anything else. Call (855) 342-5978 for an exact quote. Estimates are free.
Book Chimney Cap & Crown Work in Bensonhurst
If you’ve got a crack in the crown, a cap that’s seen better days, or a stack that generations of additions have left non-standard, we’ll put a camera on it and show you what’s actually there before you sign off on anything. Nothing gets recommended that you can’t see for yourself, and we’ll say plainly when work can wait a season. Call (855) 342-5978 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Chimney Sweep Gravesend.